Jonathan Bennett
New member
Hello,
I am a new user, but from reading the forums have seen some extremely good advice offered on here so I hope somebody can help me understand this problem.
I have recently purchased the Technics SX PR603M, second hand. When I tested it there was no problem but when I got it home things changed.
When first powered up everything appears to be fine (all LEDs come on, the screen loads up, sound is produced). However, after around 1 minute all of the LEDs switch off apart from the main power LED and floppy drive LED, the display goes off with only the backlight on (blank blue flashing screen), and no sound is produced. If I leave it switched on everything returns intermittantly until a key or button is pressed then it cuts out again.
As the key board functions perfectly for the short period of time it works I think it may be a problem with the internal power supply, but this is only a guess.
Is anyone familiar with this model/fault, or can anyone help at all???
Thanks
I am a new user, but from reading the forums have seen some extremely good advice offered on here so I hope somebody can help me understand this problem.
I have recently purchased the Technics SX PR603M, second hand. When I tested it there was no problem but when I got it home things changed.
When first powered up everything appears to be fine (all LEDs come on, the screen loads up, sound is produced). However, after around 1 minute all of the LEDs switch off apart from the main power LED and floppy drive LED, the display goes off with only the backlight on (blank blue flashing screen), and no sound is produced. If I leave it switched on everything returns intermittantly until a key or button is pressed then it cuts out again.
As the key board functions perfectly for the short period of time it works I think it may be a problem with the internal power supply, but this is only a guess.
Is anyone familiar with this model/fault, or can anyone help at all???
Thanks